Diehead & Chaser Seminar

Setting The Grinding Fixture

When all chasers of the set have been moved ahead and locked on their blocks for grinding, put the chaser and block into the proper size adapter, which has been clamped by the screw in the center slot of the Chaser Grinding Fixture.

All adapters are designed to hold a chaser at a twelve degree angle for grinding the chip clearance angle.

Correct setting of the chaser for grinding the hook angle is obtained by turning the grinding fixture head to the desired angle reading on degree scale of fixture head bracket and tightening clamp screw.

The face angle setting is made by turning the fixture on its base and tightening base lock screw. To grind the correct face angle of 1 degree 30’ on the Chaser and Block assembly. If the hook angle is increased by 5 degrees the base reading should be advanced by 1 degree.

 

RSVP Tooling, Inc. - Circular Chaser Thread Rolling System - Diehead & Chaser Seminar - Setting The Grinding Fixture Image

 
RSVP Tooling Link Icon Additional Seminar Information

1. Seminar Outline
2. RSVP Tooling, Inc. - Information Sheet
3. Diehead Maintenance Check List
4. RSVP DR Diehead Parts List
5. Using The Micrometer Setting Gauge
6. How To Grind Circular Chasers
7. Setting Chaser Ahead For Grinding
8. Setting The Grinding Fixture
9. Grinding The Chaser

10. Useful Hints On Chaser Care & Threading
11. Problem Solving
12. Guide To Checking Block Wear
13. Micrometer Barrel Certification
14. Suggested Grinds - 4 Per set Straight
15. Suggested Grinds - 5 Per set Straight
16. Suggested Grinds - Taper
17. Chart For Micrometer "AA" Readings

RSVP Tooling PDF Icon

Download this page as a PDF
Download this seminar as a PDF
Download the RSVP Tooling Catalog as a PDF

Follow RSVP Tooling on: