Chaser Springs: |
Visually inspect that they function without chip interference or being bent. |
Pins in Block: |
Examine that they are not broken or bent. |
Cams on Diehead Cup: |
Check for excessive wear on edge of cams. |
Guide Pins: |
Pin in adjusting plate should not move, if so replace. |
Adjusting Plate: |
If guide pin had to be replaced, check plate if not warped. |
Floating Bushing: |
This bushing is in the body, which the guide pin runs through, make sure there is enough bushing showing through the body hole. |
Plunger: |
Remove and inspect control point at tip edge. |
Spring Plunger: |
If plunger is being replaced make sure spring still has compression. |